Answer
Aug 28, 2024 - 04:30 PM
Reprogramming your RFK32SST Excalibur car alarm remote involves pairing the remote with the car alarm system so that it can communicate effectively. The RFK32SST is part of the Excalibur series of car alarms, which are produced by Omega Research and Development, a company known for its vehicle security systems.
Steps to Reprogram Your RFK32SST Excalibur Car Alarm Remote:-
Prepare Your Vehicle:
- Ensure your vehicle is parked in a safe location, and all doors are closed. The alarm system must be disarmed before beginning the programming process.
-
Locate the Valet/Programming Button:
- The Valet/Programming button is typically hidden beneath the dashboard or in the driver's side kick panel. It is a small, push-button switch that is crucial for entering programming mode.
-
Turn the Ignition Key to the "On" Position:
- Insert the key into the ignition and turn it to the "On" position (do not start the engine). This powers up the vehicle's electrical system and prepares the alarm system for programming mode.
-
Enter Programming Mode:
- Within 5 seconds, press and release the Valet/Programming button three times.
- The vehicle’s parking lights should flash, and you may hear a chirp from the alarm siren, indicating that the system is now in programming mode.
-
Program the New Remote:
- Immediately after entering programming mode, press and hold the "Lock" button on the new RFK32SST remote you wish to program.
- Hold the button until you see the parking lights flash or hear the alarm chirp again. This indicates that the remote has been successfully programmed to the alarm system.
-
Exit Programming Mode:
- Turn the ignition key back to the "Off" position. The system will exit programming mode automatically, and the alarm will return to normal operation.
-
Test the Remote:
- Test the newly programmed remote by pressing the "Lock" and "Unlock" buttons to ensure it is functioning correctly. The vehicle's doors should lock and unlock, and the alarm should arm and disarm as expected.
- Programming Timeout: If you do not perform the steps within the specified time frames, the system may exit programming mode automatically. If this happens, repeat the steps from the beginning.
- Multiple Remotes: If you have more than one remote to program, repeat the programming steps for each remote without turning the ignition off between each one. The system can usually learn multiple remotes (up to 4 in most cases).
- Battery Check: Ensure the battery in the RFK32SST remote is fresh. A weak battery can cause programming to fail or result in unreliable operation after programming.
- Factory Reset: If the remote programming does not work as expected, you may need to reset the alarm system and attempt the programming process again. Refer to the system's user manual for instructions on performing a factory reset.
Reprogramming the RFK32SST Excalibur car alarm remote involves entering the alarm system's programming mode using the valet button and pairing the new remote with the alarm by pressing the remote's button. Ensure you follow the steps promptly and accurately to avoid timing out of the programming mode. If you encounter any issues, refer to the vehicle's alarm manual or contact Omega Research and Development for further assistance.
Add New Comment